Tool Stand with ball and saving claw legs

A tool or brush stand with 26 holes of various sizes (listed below).
It is stylishly designed so it looks good while your are being creative (painting, modeling, sculpting, drawing, carving, or just tinkering).
This is a 3D printed stand of my design mounted on a ceramic tile for stability with a felt bottom to protect your work surface.
It is hand painted. I painted a layer of primer then several coats of acrylic paint with highlighting, then sealed it with a matte finish varnish. The ball in the claw is then given a gloss coat to make it stand out.

The holes are about:
9 mm - 16 holes
12mm - 6 holes
15mm - 2 holes
18mm - 2 holes
Sizes vary based on painting, but items these sizes should fit (hole may be a little larger).

Paint may vary a little since it is done by hand. The top will be dark green, the legs are brown with a brown/green mix for the vine wrapping the leg. The claws are saving light brown and the ball is purple.

A small rectangle hole (15m x 7mm) in the back for a small retractable blade.
A larger rectangle hole (37mm x 4mm) for a ruler.